Some time ago I bought a cheap Suzuki GT250 parts bike from an online auction site. Bike itself was in pretty bad condition but I taught I could utilize at least some parts from it. Lots of parts were missing but frame had still front forks, swingarm, fuel tank and engine attached to it. Few extra pieces, like Honda CB125 exhaust pipes, which I sold, were included to the deal as well. After disassembling parts from the frame I turned my attention to the engine. It wasn't a big surprise that it had seized pistons and plenty of rust after sitting outside and water getting in. After taking the engine a part I decided to clean it up a bit and utilize it as a mock-up engine for building exhaust pipes et cetera while I put together actual engine for this bike.
 |
| Suzuki GT250 engine out of a spare parts bike |
I decided to use soda to clean upper and lower crankcase. Good thing about soda blasting is that it isn't abrasive like sand blasting so it doesn't require as much prep work since you don't have to mask as many spots. Bad thing about it is that it's rather corrosive if parts are not cleaned well afterwards.
Before blasting I used a brush and some solvent like brake cleaner to remove excess dirt and grease which would have just ended up disturbing soda blasting process. Below you can see few closeups of lower crankcase before and after soda blasting. I soaked them in warm water after blasting to get leftover soda out of them. Otherwise it would have ended up corroding the surface.
 |
| Lower crankcase before soda blasting |
 |
Soda blasting equipment:
gun, water separator for air compressor and soda |
 |
I put both crankcases to a big bucket with warm water
after soda blasting to dissolve leftover soda out of them
|
 |
| Lower crankcase after soda blasting |
